Electric Appliance / Bussard Appliance is not responsible for any injury or damage that could result to customer or appliance during troubleshooting.
Noisy:
  1. Check rear drum bearing bearing kit.Part number is we25x205.
  2. Check front drum glides.Part number is we1m481 and front bearing we3m26.
  3. Check idler pulley. Part  number is we12x81.
  4. Check main motor.Part number is we17x10010.

Won't Run

  1. Check and  make sure you have power to dryer.
  2. Check cord at terminal block at back of dryer. part number is 5304409888.
  3. Check door switch. Unplug dryer bypass door switch.Plug dryer back in if it runs that was your problem.
  4. Check thermal fuse if it has one. Unplug dryer bypass fuse plug dryer back in if it runs
    that was your problem.
  5. check main motor.part number is we17x32 or we17x10010.

Won't Tumble

  1. Check belt, if motor runs and drum does not tumble you may have broken belt.

No Heat

  • Gas Dryer
    1. Check and see if ignitor glows, if ignitor does not glow either it is bad or no power
      is coming to it. For no power check flame sensor or check t/stats or bring in parts and we will check for free.Caution igniter is very very fragile. ***
    2. If igniter glows for 15 seconds and then shuts off you could have bad coils on top of valve.
    3. check flame sensor.
  • Electric Dryer
    1. Check and make sure you have 230v to dryer.the motor only needs 115v to run, but you need 230v for heat.
    2. Check heating element.
    3. Check terminal block at back of dryer.
    4. check all t/stats.

Heats Poorly

  • Gas Dryer
    1. Check your dryer vent and make sure it is not plugged.
    2. Check blower on motor make sure it is not plugged.
    3. Watch your burner assembly and make sure it lights every time, if ignitor glows about 15 seconds and
      then goes off and no gas flame. You could have bad gas coils. You may have to watch
      your burner assembly for 15 minutes before you will see this.
  • Electric Dryer
    1. Check and make sure your vent is not plugged.
    2. Check blower on motor.
    3. Check all t/stats.